Networker server version is 7.6.4-3.
Clone are maid automaticaly whith backup of group.
Even, we make à manuel backup whith saveset from datadomain in vtl mode, we have the same problem.
so your backup and clone not working?
have you checked the networker service is running?
also check if ports are open using rpcinfo -p <BKP SN@SRV servername>
Clone is implemented now but don't work well
But backup to physical tape work.
Clone are maid from vtl (datadomain) to physical library.
Are you sure backup succeeds? If backup fails, it is expected clone will fail.
If backup succeeds, it will choose a storage node to read and a storage node to write (if you have multiple storage node).
Please refer to Administration Guide page 229-231 “ Directing clones to a special storage node” to check whether the following values are correct:
Clone storage nodes
Recover storage nodes
Storage node to WRITE save sets
This message is usually to be found as a 'conclusion' at the end of a message 'block'.
So please look a bit closer at the time stamp.
A look at the daemon.raw file will oviously help.