Unsolved
This post is more than 5 years old
155 Posts
0
1141
Configuring Cluster node in Networker
Hi All,
Requesting community me,ber to help me understand how to Configure Cluster node in Networker 7.5, and how does the licensing happen in case of a clusted client.
As the configuration needs to be done with the clusted ip or the physical ip?
Bebo2k
544 Posts
1
June 9th, 2012 15:00
Hi SurajPujari,
You can find the configurations to be implemented to backup virtual clients from the following Powerlink articles:
https://solutions.emc.com/emcsolutionview.asp?id=esg50945
https://solutions.emc.com/emcsolutionview.asp?id=esg115063
For more information you can check the Admin guide Chapter 19 ( Cluster support) where it mentioned the steps to configure virtual clients on the supported platforms.
Regarding licensing, Cluster client connection enablers are no longer required. Cluster client licensing is now based solely on the client connection enablers. However, existing cluster client connection licenses will still be honored. Each physical node of the cluster requires a client license. Virtual clients of a cluster do not require their own license.
NetWorker client licensing differentiates between stand-alone computers and computers that participate in a cluster. The licenses are bound to physical nodes. Therefore, once a client connection license is allocated, any virtual clients that are running on that physical node can be backed up.
Hope this helps you and answered your question.
Thanks,
Ahmed Bahaa