Unsolved
This post is more than 5 years old
2 Posts
0
979
Start backup automatically
Hi
Many thanks in advanced
Can someone help me to perfom a backup of a client splited in 3 groups, in each group there is a differents saveset from the same client. This backups must start autmatically, that is the say, when first group backup's is performed, the next backup of second group will starts autmatically, etc.
Many thanks
Abdel
,
bingo.1
2.4K Posts
0
December 7th, 2017 03:00
Probably ;-) - But first of all we need to know the NW version you work with. I just alssume you run NW 8.x
In general, there are several ways to achieve the same result:
- The easiest way would be to have 1 group with 1 client resource only and limit the group or client parallelism to 1.
So one stream/set after the other will be created (sequentially, of course)
- Another method is to setup the NW resource appropriately. Example:
- Start the first group at 18:00
- Start the next one at 19:00
- Start the last one at 20:00
This however, is not a conditional backup (each group will start at its scheduled time)
- Create a script which runs the groups sequentially:
savegrp -G group_1
savegrp -G group_2
savegrp -G group_3
Abdelwaheb_e37547
2 Posts
0
December 8th, 2017 02:00
Hi,
Many thanks for your reply, and sorry for delay
The NW version is 8.2
My client is HyperV cluster with 9 nodes and CSV 25 To, on each there is
many VMs. Olds months ago, the backup is perfomed in one only group with
all nodes and all VMs (120) when the number of VMs growth (140 VMs) the
backup comes fails, so I had split the initial group in 3 groups each with
differents savesets, the 3 groups are backped correctelly without error,
but I need to start them manualy, because only NMM instance must bu run in
the same time on the cluster HyperV. How can I plan to perform backup of
these 3 groups automatically that is the say, when the backup's first
group is finished then the second group will start, etc... and with this
senario we are sure that only one instance of NMM is running on the
cluster. Can I do it with the parallelism set to 1 ?
BR
Abdel
-
Original Message -
From: bingo
To: "Abdelwaheb Fehri AYARI"
Sent: Jeu, Dec 7, 2017, 12:53 PM
Subject: Re: - Start backup automatically
DECN (https://community.emc.com/?et=watches.email.thread)
Start backup automatically
reply from bingo
(https://community.emc.com/people/bingo?et=watches.email.thread) in
NetWorker - View the full discussion
(https://community.emc.com/message/991599?et=watches.email.thread#991599)
bingo.1
2.4K Posts
0
December 9th, 2017 02:00
The easiest way is to start the groups via a script, as suggested.