Unsolved
This post is more than 5 years old
1 Message
0
1997
Auto-Assign Port VLAN based on Connected Device (e.g. VOIP phone)
Hi all
I have some N3024P switches that need to be set up.
There is a requirement to automatically place VOIP phones that are connected to the switch into the voice VLAN automatically.
Is this possible with these switches? I have been looking at GVRP in the CLI but it's not clear to me how it can help with this.
What I would imagine is somewhere that I can enter a MAC OUI, e.g. a specific manufacturer, and then state what VLAN to place that MAC within.
Thanks for the assistance
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
June 20th, 2016 09:00
GVRP is used more for propagation and pruning of VLANs throughout the network. with the N-series you can define a VLAN to be the "voice" VLAN. And with the use of LLDP the switch can automatically take the Voice traffic and place it in the defined voice VLAN. Here is a KB article that goes into further detail of exactly how to accomplish this.
http://dell.to/1M2vobW
Let us know if you have any questions.