Unsolved
This post is more than 5 years old
1 Message
0
804
DELL N1548 in redundant scenario
I'm going to setup n.4 DELL N1548 switches; they are linked throught uplink ports (10GB) as you can see in the image attached. There are n.3 servers; each server has n.2 NICs mounted using bonding mode 6 (balance-alb - Adaptive Load Balancing ) linked to 2 different switch.
Could you give me some advices on how to configure a redundant scenario with those switches ? STP, LACP, routing, etc
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
June 21st, 2017 11:00
Have you looked into stacking the two switches? As a stack the two switches would behave as one logical switch. The LAGs could split across both switches, and if one switch/link goes down the other switch in the stack would continue working.
Here is a KB article on stacking those switches.
http://dell.to/2srhKtF