Unsolved
This post is more than 5 years old
1 Message
0
8776
Interface status is up but protocol down on DELL s6010
Hi All,
i'm configuring a cluster to do pxe boot over dell s6010 switch. all the interfaces are showing up but protocol is down and machines are not able to reach management node. ports are assigned vlan 120
please can you provide some guides to resolve this issue
Dell(conf-if-fo-1/14)#do sh ip int br
Interface IP-Address OK Method Status Protocol
fortyGigE 1/1 unassigned NO Manual up down
fortyGigE 1/2 unassigned NO Manual up down
fortyGigE 1/3 unassigned NO Manual up down
fortyGigE 1/14 unassigned NO Manual up down
ManagementEthernet 2/1 unassigned NO Manual up not present
ManagementEthernet 3/1 unassigned NO Manual up not present
ManagementEthernet 4/1 unassigned NO Manual up not present
ManagementEthernet 5/1 unassigned NO Manual up not present
ManagementEthernet 6/1 unassigned NO Manual up not present
Vlan 1 unassigned NO Manual up down
Vlan 5 10.8.230.221 NO Manual up down
Vlan 120 10.8.120.222 NO Manual up down
fortyGigE 1/1 is up, line protocol is down
Hardware is DellEth, address is f4:8e:38:69:5a:b5
Current address is f4:8e:38:69:5a:b5
Pluggable media present, QSFP type is 40GBASE-SR4
Wavelength is 850nm
No power
Interface index is 2097157
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :f48e38695ab5
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 40000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 01:17:23
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
--More--tatistics:
0 packets, 0 bytes, 0 underruns
--More-64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
--More--ver 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
--More--hrottles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
--More--ut 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
--More--ce last interface status change: 01:16:40
--More--
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
September 20th, 2017 09:00
Have you issued the command # no shut, on each of the interfaces? That should bring them up.
http://dell.to/2i2lrTh