Unsolved
This post is more than 5 years old
1 Message
0
16963
N3024P switch
I got these messages scrolling on the console screen when I connect n-tron L2 switch to any switchport
dh#
<187> Mar 24 23:25:05 dh-1 DOT1S[dtlTask]: dot1s_txrx.c(306) 273 %% dot1sBpduReceive(): Discarding the BPDU, since it is an invalid BPDU type
What can be done to stop them?
Thank you for help.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
March 25th, 2016 11:00
You can use the command # no logging console, to disable the messages being displayed on the console screen. They will still be logged in the switch logging though. I would check and make sure that the switches are running the same mode of spanning tree. Was this n-tron switch previously configured on a different network? If so, perhaps the previous configuration is interfering.
Firmware can also play a big part in interoperability. Here is the latest firmware for the N3024P : http://dell.to/1UgiYkh
I would also check the firmware on the n-tron. After update then check for any behavior changes.