Unsolved
3 Posts
0
2867
N3048 and s4048 Access List and SNMP enable
Hi guys, Firstly im not a network engineer I have inherited this so please be gentle If possible could you give us a hand with some basic commands on these 2 switches? Basically I have a VLAN on both switches and need to add and Access-list and have a rule to enable SNMP from 1 particular IP address. This is obviously without disturbing any other traffic I have done this before on cisco switches but not entirely sure how to do this on the DELL switches via CLI So I have tried the following :- "ip access-lists SNMPMUTINY" then not sure after this - something like "access-list SNMPMUTINY permit 10.0.0.56" "access-list SNMPMUTINY deny any" END Then add back to privileged Mode snmp-server community ****** RO SNMPMUTINY Do that sound about right?
DELL-Josh Cr
Moderator
Moderator
•
8.5K Posts
0
May 10th, 2019 11:00
Hi,
Is that ip only being used for snmp? You could also allow just the ports for snmp on that ip as well.
ITRECORD
3 Posts
0
May 14th, 2019 02:00
yes it is - however I have been asked to just allow that ip to read on SNMP on the DELL switches
Any ideas on how ?
DELL-Josh Cr
Moderator
Moderator
•
8.5K Posts
0
May 14th, 2019 09:00
Use snmp-server community command and set it to ro for that ip address https://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_networking/esuprt_net_fxd_prt_swtchs/networking-n3000-series_administrator-guide_en-us.pdf Page 2133
ITRECORD
3 Posts
0
May 17th, 2019 03:00
Thank you will try the manual !!