Unsolved
This post is more than 5 years old
68 Posts
0
3575
N4032F Management IP problems
Hi
After I get a New N4032F switch I can assign an IP and default gateway to vlanXX, then if I recover the device to redeploy it using another vlan....lets say vlan1 and try to assign it an different IP it would take it
I get this warning
Warning! Notice! The configured default gateway will not take effect until an interface belonging to
the same subnet as the configured Gateway is created and activated.
I have deleted the existing config and reset it back to factory defaults and it still cannot ping itself
Please Help
thks
Glenn
DELL-Josh Cr
Moderator
Moderator
•
8.5K Posts
0
February 8th, 2017 16:00
Hi,
What firmware version are you using? Are you using the out of band management or in band management?
DELL-Josh Cr
Moderator
Moderator
•
8.5K Posts
0
February 9th, 2017 07:00
Try updating the firmware http://www.dell.com/support/home/us/en/19/Drivers/DriversDetails?driverId=P3F19&fileId=3594871950&osCode=NAA&productCode=networking-n4000-series&languageCode=en&categoryId=NI
There are some fixes that may help.
glenn77
68 Posts
0
February 9th, 2017 07:00
console(config-if-vlan1)#ip address 172.16.3.9 255.255.0.0 secondary
Failed to set IP address on interface.
console(config-if-vlan1)#ip address 172.16.3.9 255.255.0.0
console(config-if-vlan1)#exi
console(config)#exi
console#ping 172.16.3.9
Pinging 172.16.3.9 with 0 bytes of data:
----172.16.3.9 PING statistics----
4 packets transmitted, 0 packets received, 100% packet loss
round-trip (msec) min/avg/max = <10/<10/<10
glenn77
68 Posts
0
February 9th, 2017 07:00
In band management
Ver 6.2.7.2
It seems that once I first set an IP and gateway ten it sets it in stone and cannot be changed
it can be vlan1 or any other vlan I create one crack at it and then its over :(
schrorg
9 Posts
0
February 14th, 2017 12:00
Hi,
I guess, this would be the case if the vlan is down.
Is there any active switch port in vlan 1?
Cheers,
Robin