Highlighted
felixhoude
1 Copper

PowerConnect 3448P is constantely rebooting after failed firmware upgrade

Hi!

Our PowerConnect 3448P is constantely rebooting after failed firmware upgrade, here is what it shows. Any ideas how to fix this? I tried some of the firmware/bootcode upload through XModem, I don't think I have matching ones...

Boot1 Checksum Test...............................PASS
Boot2 Checksum Test...............................FAIL
Flash Image Validation Test.......................PASS

BOOT Software Version 1.0.1.01 Built  15-Jun-2006  11:42:56

 Carrier board, based on PPC8247
 128 MByte SDRAM. I-Cache 16 KB. D-Cache 16 KB. Cache Enabled.

Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.
Preparing to decompress...
 100%
Decompressing SW from image-1


LZMA: Compressed File Version not supported!

Switching to the second image ...


 Perform WARM BOOT ...


Boot1 Checksum Test...............................PASS
Boot2 Checksum Test...............................FAIL
Flash Image Validation Test.......................PASS

BOOT Software Version 1.0.1.01 Built  15-Jun-2006  11:42:56

 

Thanks,

Felix

Tags (3)
0 Kudos
2 Replies
bh1633
3 Cadmium

Re: PowerConnect 3448P is constantely rebooting after failed firmware upgrade

It looks like the boot code does not match the firmware.

What version of firmware are you XMODEMing to the switch? You should be using the latest (2.0.0.29).

0 Kudos
felixhoude
1 Copper

Re: PowerConnect 3448P is constantely rebooting after failed firmware upgrade

That is right... I finally got it to work. I am not sure why it didn't work with tftp the first time as it upload the same file using XModem after trying to go back without sucess.

Thanks,

Félix

0 Kudos