3 Posts
0
1856
Powerconnect 3548
hi, I have installed several pcs of the brand and a server cabinet with 2 poweredge 2950. The problem is that configure through the serial cable and boot the correct powerconnect 3548. but it is impossible for me to visualize via web in browser the ip to access. I have no way. Let's see if you can help me. thank you very much.
ARTISER
3 Posts
1
August 18th, 2018 04:00
Thanks Daniel, there was actually a problem with the ip and the mask, I had given incompatible parameters, 16/24 I did not realize and hence the problem. The problem is solved!!
ARTISER
3 Posts
0
August 8th, 2018 03:00
what I need is to monitor and administer the 3548 powerconnect through the web gateway, through the browser putting the ip, but I have no way of knowing how to do it, when configuring it, reset the device and assign an ip address, but it fails and does not shows the page I'm stuck with this. Thank you
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
August 8th, 2018 11:00
The setup wizard guides you through the initial config of the switch, which it sounds like you did. There is a section in the getting started guide that you can use to double check.
Page 17: https://dell.to/2nmmcq9
Is the switch IP and your laptop IP within the same subnet?