1 Copper

Reassign untagged access ports from VLAN 1

Hello. I have a stack of two N3048 switches.

I'd like to use VLAN segregation and routing and have created VLAN 40, however it doesn't appear to route to VLAN 1 and I have read that the VLAN 1 is reserved and can not be used like this.

So my question is: is it safe to move untagged access ports from VLAN 1 to something else, and will this enable VLAN routing?

What is the most efficient way to do this?

Any help will be much appreciated.


I already have:


1 default Po1-128, Gi1/0/1-48, Te1/0/1-2, Te1/1/1-2, Gi2/0/1-21,
Gi2/0/23-26, Gi2/0/35, Gi2/0/37-48, Te2/0/1-2, Te2/1/1-2

3 VC Gi2/0/27-36 

40 xLAN Gi2/0/22 


Routing Interfaces:

Interface State IP Address IP Mask Method
---------- ----- --------------- --------------- -------
Vl1       Up Manual
Vl40      Up Manual
Vl3       Up Manual

0 Kudos
1 Reply

Re: Reassign untagged access ports from VLAN 1


You should just be able to assign the ports to that vlan without any issues. Page 820 https://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_networking/esuprt_net_fxd...

Josh Craig
Dell EMC Enterprise Support Services
Get support on Twitter @DellCaresPRO
0 Kudos