Unsolved
This post is more than 5 years old
1 Message
0
19528
STACK PRIORITY SWITCHS N3024
Hello all!
Is there a command or specific configuration to set the master switch in a stack cenario ? On CLI there is not a option to set stack priority.
Thanks!
vt1012
212 Posts
0
October 1st, 2015 08:00
If this is the initial setup, you should be able to cable the stack together, then bring the selected master switch all the way up before bringing up the remaining switches. This should make it master. If this is a stack already in production, you should be able to use the standby command to set the backup master switch, then failover to that switch using the "initiate failover" command from the stack configuration mode.
Hope this helps!
-B