Unsolved
2 Posts
0
1585
Some ports on N4032F stopped working
Out of the blue, after a shutdown, 4 ports from this switch stopped working. I can use the same cable in any other port and it will work, but i don't get any link on those 4 ports. Oddly enough does display when the transciever is connected and disconnected, but no link.
Already tried shutdown/no shutdown to no availe
Is there a way to make sure the port is actually dead? Or could i be missing something that might fix it?
Thanks!
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
July 27th, 2018 06:00
There is a built diagnostic that you can run by issuing the following command.
console#show fiber-ports optical-transceiver
Page 2021: https://dell.to/2GSoHcQ
Another test you can perform is the loopback test. This test is simply plugging the switch into itself. When doing so you should see link lights come on the interface.
Is there anything recorded in the logs regarding these interfaces?
console# show logging
ArturoCamacho
2 Posts
0
July 30th, 2018 12:00
Logging does show optics being connected and disconnected on the port.
<188> Jul 30 18:32:54 0.0.0.0-1 TRAPMGR[trapTask]: traputil.c(721) 30421 %% INSERT_OPTICS_PLUS: Optics SFP+ inserted in Te1/0/2
<188> Jul 30 18:32:59 0.0.0.0-1 TRAPMGR[trapTask]: traputil.c(721) 30422 %% REMOVED_OPTICS_PLUS: Optics SFP+ removed from Te1/0/2
Unfortunately no link with the loopback test. Oddly enough it's the first 4 ports that stopped working. Everything else looks fine. Think it's anything that could be easily fixed?
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
July 30th, 2018 12:00
Can you post up the running config? I can help make sure there is nothing in the config causing this.