This post is more than 5 years old
4 Posts
0
3476
Updating a 4810
I have access to the support site and get the latest firmware for the 4810 - but the release note suggests I need new boot code too u-boot.1.2.0.5.bin - but that does not appear in the list of available downloads. Where can I can that from ?
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
May 16th, 2017 12:00
Found it! Once you log into your force 10 account, scroll down to the bottom of the page.
"Note: To see the full list of Supported Software downloads, please click here"
Once you click the link you will be taken to a page with more links, and the uboot link is listed.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
May 12th, 2017 13:00
The u-boot image is built into the firmware download. You should just be able to run the update command in the release notes, and it will pull the uboot image from the firmware file.
What uboot version is the switch currently at?
pappleby64
4 Posts
0
May 15th, 2017 08:00
After applying the image the current state is
Dell Networking OS Version : 9.11(2.0P0)
Boot Flash : 1.2.0.2
it appears to running fine and able to reload.
However, the release note states that version 1.2.0.5 is required and also gives no indication that the boot code is included.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
May 15th, 2017 11:00
What happened when you ran the upgrade boot command?
pappleby64
4 Posts
0
May 15th, 2017 14:00
This is standalone unit, not in a stack. upgrade boot command needs the file doesn't it ? hence the original question.
pappleby64
4 Posts
0
May 16th, 2017 14:00
Thanks, not sure I would have ever found that ....