NxG33k
6 Indium

Re: VLAN Routing and Config

I am able to see my switch when plugged into the correct VLAN, but unable to ping the other VLANS.

192.168.10.1 can ping 192.168.10.210

192.168.16.1 can ping 192.168.16.210

0 Kudos
NxG33k
6 Indium

Re: VLAN Routing and Config

I guess I have been a little impatient with running commands. Now when running the show ip route I get

192.168.10.0/24 directly connected vlan 2

192.168.16.0/24 directly connected vlan 3

I can also ping from 192.168.16.1 to 192.168.10.1 but cannot the other way around

0 Kudos
Moderator
Moderator

Re: VLAN Routing and Config

Can you run this command please:

show ip interface

Post the output here.

Thanks

Daniel Covey
Dell EMC| Enterprise Support Services
Get support on Twitter:@DellCaresPRO
Download our QRL app:iOS, Android, Windows
Dell Networking Resources

0 Kudos
NxG33k
6 Indium

Re: VLAN Routing and Config

Management Interface:

IP Address..................................... 192.168.11.210

Subnet Mask.................................... 255.255.255.0

Default Gateway................................ 192.168.11.254

Burned In MAC Address.......................... D067.E583.5584

Network Configuration Protocol Current......... None

Management VLAN ID............................. 1

Routing Interfaces:

                                                   Netdir   Multi

Interface    State  IP Address      IP Mask         Bcast    CastFwd

----------   -----  --------------- --------------- -------- --------

vlan 2       Up     192.168.10.210  255.255.255.0   Disable  Disable

vlan 3       Down   192.168.16.210  255.255.255.0   Disable  Disable

0 Kudos
NxG33k
6 Indium

Re: VLAN Routing and Config

The vlan 3 State is Up, the laptop went to sleep when I ran the Show cmd. But I have verified that pings are still acting the same and reran the cmd and now have Up Up

0 Kudos
Moderator
Moderator

Re: VLAN Routing and Config

So VLAN 3 is down, which would mean that either there is no port configured for VLAN 3, but in this case we have g25. Or the port  configured in VLAN 3 is down also.

The computer you have static address assigned for VLAN 3, it is plugged into port 25 correct?

If you do a show interface status command it should show if the port is up or down.

Daniel Covey
Dell EMC| Enterprise Support Services
Get support on Twitter:@DellCaresPRO
Download our QRL app:iOS, Android, Windows
Dell Networking Resources

0 Kudos
NxG33k
6 Indium

Re: VLAN Routing and Config

The vlan 3 State is Up, the laptop went to sleep when I ran the Show cmd. But I have verified that pings are still acting the same and reran the cmd and now have Up Up

0 Kudos
Moderator
Moderator

Re: VLAN Routing and Config

I do not see anything left in the config that would cause this kind of behavior. Have we saved the running config and rebooted recently? Sometimes a reboot can help in situations like this.

Daniel Covey
Dell EMC| Enterprise Support Services
Get support on Twitter:@DellCaresPRO
Download our QRL app:iOS, Android, Windows
Dell Networking Resources

0 Kudos