Highlighted
Dusty Rah
1 Nickel

"show interfaces trunk" m6220 command

Jump to solution

Is there an equivalent command on m6220 switch for "show interfaces trunk" which works on Cisco?

 

I want to be able to see all the ports associated with trunk mode and which vlans they allow and are not pruned. The Cisco output looks like below:

 

m6220ca.example.com>show interfaces trunk
Port        Mode         Encapsulation  Status        Native vlan
Fa0/18      on           802.1q         trunking      1

Port        Vlans allowed on trunk
Fa0/18      1-1005

Port        Vlans allowed and active in management domain
Fa0/18      1,101

Port        Vlans in spanning tree forwarding state and not pruned
Fa0/18      1,101

Thank you for your assistance!

0 Kudos
1 Solution

Accepted Solutions
Moderator
Moderator

Re: "show interfaces trunk" m6220 command

Jump to solution

Hi,

If you use the show vlan command it will tell you which ports pass that vlan. Page 820 https://downloads.dell.com/manuals/common/powerconnect-m6220_reference%20guide_en-us.pdf

Show interfaces detail gives similar information about the VLANs on a port. Page 425.

Thanks,
Josh Craig
Dell EMC Enterprise Support Services
Get support on Twitter @DellCaresPRO
1 Reply
Moderator
Moderator

Re: "show interfaces trunk" m6220 command

Jump to solution

Hi,

If you use the show vlan command it will tell you which ports pass that vlan. Page 820 https://downloads.dell.com/manuals/common/powerconnect-m6220_reference%20guide_en-us.pdf

Show interfaces detail gives similar information about the VLANs on a port. Page 425.

Thanks,
Josh Craig
Dell EMC Enterprise Support Services
Get support on Twitter @DellCaresPRO