Unsolved
This post is more than 5 years old
1 Message
1
1024
Dell Power Connect 3324
I have 3 Dell Power Connect 3324 Switches that form my network which also serves has an IP phone system. I remember when I installed the switches they had to be set to give IP addresses only thru the Phones. However, I was able under guidance of Dell to set some of the ports so that no phone was needed. My problem is that I lost the directions that I had used and don't don't know where to start because I don't even know what to called in the manual.
Any help will be appreciated
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
October 20th, 2016 13:00
Do any of the three switches still have this configuration? You can use the command # show run, to show you how the configuration is set. Then use the settings from one switch to configure the other.