randolph551
1 Copper

946 AIO printer

Loaded firmware and now printer only beebs. Will not start up.

0 Kudos
1 Reply
Highlighted
Moderator
Moderator

Re: 946 AIO printer

You installed the firmware using the USB Cable, correct. The firmware you installed was R152145.exe, correct?

 

Disconnect your printer. Download and run this patch to completely remove the printer from your computer.

 

Restart your computer.

 

Download the proper drivers.

 

XP Drivers

 

Vista 32-bit Drivers

 

All other drivers

 

 

Go to device manager(right click my computer, left click properties, left click hardware, left click device manager)

 

Go to the USB Controller section and click the + sign.

 

Starting at the bottom, USB Root Hubs, and working your way to the top, USB Universal Controllers, un-install everything in that section.

 

Restart your computer. Windows will find everything again and correct the problem one. Please be patient. The new hardware wizard may work 3-5 minutes before it's done.

 

Install the proper drivers. You'll be prompted when to connect your printer(powered on)

 

Scanning

 

Scanning using USB connection, open the Dell All-In-One Center, click on scanning and copying and scan from there.

 

Scanning wirelessly, use the scan buttons on the printer.

 

 

Rick

#DellRockstar

What is a Dell Service Tag and how do I locate it? 

Original poster, If you have solved your problem, can you please mark the correct thread(s) with your solution. Thanks 

Welcome to Dell Community!

#DellWorld 2012

#DellWorld 2015

#DellEMCWorld 2016

#MicrosoftMVP - Windows Expert-Consumer April 1, 2012 to March 31, 2015

0 Kudos