Start a Conversation

Unsolved

KI

3 Posts

1778

October 24th, 2019 04:00

OMIVV5 Not working with VMware ESXi, 6.7.0, 13006603

Hi everyone,

 

We are running OMIVV5 with VMware ESXi, 6.7.0, 13006603. 

Deployment compliance is everything green, but within the "Configuration Compliance" & "Management Compliance" they keep on saying 'Non-Compliant'.

Checked the following things:

Host Credential Profile --> all servers are part of this
CSIOR --> is enabled
SNMP Trap --> SNMP agent is enabled (just to verify, is this the correct thing mentioned with SNMP trap?)
WBEM Configuration --> ESX is running this service
iDRAC Firmware Version --> 3.34.34.34
iDRAC License --> OpenManage Enterprise Advanced

 

Any thoughts?

2.9K Posts

October 24th, 2019 09:00

What server model is ESXi installed on, and what firmware does the host have for the BIOS and iDRAC? Looking at the manuals, it looks like this could be a factor.

October 24th, 2019 23:00

bios:        2.2.11

idrac:      3.34.34.34

host type:              PowerEdge R740xd

October 25th, 2019 00:00

Hi KPN,

                May I know few more details about this issue :

  1. Is inventory run successfully on this hosts ?
  2. Host is shown ‘Non-compliant’ for  "Configuration Compliance" or "Management Compliance" , or both ?
  3. What is the non-compliance details, a screenshot would be greatly helpful.’
  4. One particular host is shown non-compliant or for all the hosts ?
  5. Are use using OMIVV for first time or migrated from OMIVV 4.x ?

                 If migrated from OMIVV 4.x

                               Which version of 4.x OMIVV is migrated from ?

                              What was the compliance status of the status at 4.x ?

    6. Any Error/Warning is seen at user facing logs.

Regards,

Vineeth

October 25th, 2019 04:00

Untitled.pngHi

 

1: Yes succesfull

2: Configuration compliance

3: screenshot of several screens attached

4: all of them

5: New clean install (greenfield environment)

6; Not as far I am aware, any specific log to doublecheck perhaps?

November 7th, 2019 23:00

Hi KPN,
 Thank you for the details.
 Screenshots shows that OMIVV is flagging hardware configuration drift.
 Looks like Cluster profile associated with cluster has system profile included and drift detection job has identified few hardware configuration drift for hosts at cluster.

 If the intention is to baseline the hosts at cluster to specific hardware configuration (As configurated at system profile), have a look into drift details and make necessary changes. 
 Changes can be with configuration mentioned at system profile or with all hosts hardware configuration.
 If the intention is not to baseline the hosts at cluster to specific hardware configuration, you can remove system profile from cluster profile.
 Please refer OMIVV 5.0 User Guide for more details about Cluster Profile and Configuration Drift.

Regards,
Vineeth

No Events found!

Top