PowerEdge服务器

最后回复者 07-21-2021 未解决
发表问题
青铜
青铜
531

博科300 断电后无法启动 hda1 hda2挂载失败

=>
=> boot
Map file at LBA sector 0xaab47
Blk map has an invalid version 2
Map file at LBA sector 0x1776b0
## Booting image at 00400000 ...
Image Name: Linux-2.6.14.2
Image Type: PowerPC Linux Multi-File Image (uncompressed)
Data Size: 4269595 Bytes = 4.1 MB
Load Address: 00000000
Entry Point: 00000000
Contents:
Image 0: 3190918 Bytes = 3 MB
Image 1: 1078663 Bytes = 1 MB
## Current stack ends at 0x1FAEEA68 => set upper limit to 0x00C00000
## initrd at 0x0070B0D4 ... 0x0081265A (len=1078663=0x107587)
Loading Ramdisk to 1f9e6000, end 1faed587 ... OK
initrd_start = 1f9e6000, initrd_end = 1faed587
## Transferring control to Linux (at address 00000000) ...
Installing Linux 2.6 Kernel
Attempting to find a root file system on hda2...
mount: Mounting /dev/hda2 on /mnt failed: No such device or address
Failed to mount hda2 as root!
Attempting to find a root file system on hda1...
mount: Mounting /dev/hda1 on /mnt failed: No such device or address
Failed to mount hda1 as root!
Failed to mount a root file system!
Both boot devices are inconsistent. You can run sbin/repairfs.sh to boot up the system. After the system is booted up, please run firmwaredownload to load the appropriate version of firmware.


BusyBox v0.60.5 (2006.06.20-01:11+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.

sh: can't access tty; job control turned off
#

回复数 (2)
青铜
青铜
530

环境变量

=> pri
AutoLoad=yes
BootromVerbose=no
InitTest=MEM()
LoadIdentifiers=Fabric Operating System;Fabric Operating System
OSLoadOptions=quiet
OSLoader=ATA()0xaab47;ATA()0x1776b0
OSRootPartition=hda2;hda1
SkipWatchdog=yes
baudrate=9600
bootcmd=setenv bootargs mem=${mem} ${OSLoadOptions};ataboot;bootm 0x400000
bootdelay=20
ethact=ppc_4xx_eth0
ethaddr=50:EB:1A:19:51:7A
gatewayip=10.21.5.254
hostname=sequoia
initrd_high=0x20000000
ipaddr=10.21.5.173
mem=520192k
preboot=echo;echo Type "run flash_nfs" to mount root filesystem over NFS;echo
netdev=eth0
consoledev=ttyS1
ramdiskaddr=400000
ramdiskfile=your.ramdisk.u-boot
stderr=serial
stdin=serial
stdout=serial
submask=255.255.255.0
ver=U-Boot 1.1.3 (Feb 8 2013 - 10:04:10)

Environment size: 714/4080 bytes

513

您好,根据以上提示运行sbin/repairfs.sh看是否能启动。

如还不行的话,建议更换交换机

最新解决方案
杰出贡献者