Unsolved
This post is more than 5 years old
14 Posts
0
106809
DELL Poweredge R710 HDD Problem
My poweredge r710 server hdd 4 is blinking orange and an error message is diplayed on lcd " e1810 hard drive 4 fault review clear sel".
It has 6 hdd's raid configured, showing 3 hdd.
please tell me , i have to replace hdd or it can be solved without replacement.
sajad.wani
14 Posts
0
November 3rd, 2013 06:00
I mean to say in my server i can see 3 Hdd in disk mangment. since it is raid configured. total 6 hdds, 3 should be mirrored in raid.
can u tell is it Raid 10?
and what will be the configuration, i mean is 0 mirrored to 1, similarly 2 to 3 and 4 to 5.
i didnt configure it and i dont know anything about raid config.
theflash1932
7 Technologist
7 Technologist
•
16.3K Posts
0
November 3rd, 2013 06:00
"6 hdd's raid configured, showing 3 hdd"
What do you mean by 'showing 3 hdd'?
The message means drive 4 is offline, and it is very possible it needs to be replaced. You could run diagnostics on it to be sure it is faulty or you could just plan to replace it - as soon as possible.
theflash1932
7 Technologist
7 Technologist
•
16.3K Posts
0
November 3rd, 2013 07:00
Ok ... 6 disks, 3 RAID 1's (each RAID array will show as a separate "disk" in Disk Management) ... that makes sense.
If above is correct, then you do NOT have a RAID 10 and the disk showing failed is one of two mirrored disks in a RAID 1/mirror (probably disks 4,5). Plan on ordering a replacement disk for disk 4.
sajad.wani
14 Posts
0
March 5th, 2014 06:00
can u tell me what this mean?
dell perc 6/i scsi disk device
in disk mgmt, it shows disk 0 only with three parttitions
i can see physically 6 sas hdds
theflash1932
7 Technologist
7 Technologist
•
16.3K Posts
0
March 5th, 2014 08:00
Where do you see "physically 6 SAS HDDs"?
Can you provide a screenshot of Disk Management?
sajad.wani
14 Posts
0
March 5th, 2014 21:00
6 disk connected R710 server starting form 0 to 5