Unsolved
1 Message
0
709
PowerEdge R410 Backplane issue
No matter the hard drive I put in my SAS 2, it wont show up in my raid topology or as even being alive. SAS 0,1 and 3 work fine.
However, when I pull the drive out while in config, it registers on the servers tiny info LCD screen that the HD in slot 2 has been removed.
Any ideas as to where the issue is happening? Id rather replace a cable than the whole backplane type of thing.
DELL-Chris H
Moderator
Moderator
•
8.4K Posts
0
January 2nd, 2020 05:00
Mlaxson,
Have you tried reseating the cables, as well as inspecting them for damage on either end?
Also, if you have another R410, have you tried swapping out the cables for known good ones?
I would start there, but if the cables don't resolve it I would start suspecting the backplane itself.
Let me know.