Unsolved
This post is more than 5 years old
2 Posts
0
43396
PowerEdge R730 - replace onboard S130 RAID
Hi There - I have a PowerEdge R730 that was purchased with onboard S130 software array controller. It has an 8-bay 3.5" backplane for the drives. Would like to purchase a PERC H330 raid card (P/N 405-AAEI) to do hardware RAID. I am looking to know which Dell cables will be required to do this. Any help or assistance pointing in the right direction would be appreciated! Thanks.
DELL-Chris H
Moderator
Moderator
•
8.4K Posts
0
March 15th, 2016 12:00
Thompson344,
The cable needed to run the H330 to the 3.5" backplane would be part RG13T.
Let me know if this helps.
thompson344
2 Posts
0
March 22nd, 2016 08:00
Thanks Chris Hawk! - One more question on this.. Would I need to get two of these cables? One for SATA and one for SAS?
Thanks,
Chris
DELL-Chris H
Moderator
Moderator
•
8.4K Posts
0
March 22nd, 2016 13:00
You would need two for each side of the backplane, not for sas and sata. Both will be supported regardless of if 1 or 2 cables are installed.