I was running out of space on my Poweredge T110 RAID 1 so I decided to upgrade them to 1TB hard drives. I completed a full backup of the system and I powered down, installed new hard drives and deleted the existing array, created a new array and synchronized. It completed over night. Now, both hard drives show up as in the RAID but when I try to boot and restore my backup, neither hard drive shows up even though they do in OpenManage. Is there something I'm missing? Under Open Manage, I show the Virtual Drive as well as the two 1TB hard drives. Any help would be appreciated. Thanks.
Solved! Go to Solution.
This is the driver you should be using, keeping in mind that it must first be run to extract the files (the EXE itself is not usable during the process):
If you have problems with it, you might try an older version of the driver (Hard Drive version):
In OpenManage, does it show 2 separate 1TB drives? Does it give you the option to create an array with these 2 drives?
Yes. It shows the two drives and I did create the array. I then had it synchronize. After the sync, I reboot to my acronis disk to restore my backup and the drives do jot show to restore to
The Acronis disk probably doesn't have the controller drivers so you can see the array. You will need these before it will restore your data.
So, once I install the driver for the RAID controller I should be able proceed you think? I appreciate your time. Thanks.
Are you talking about the RAID Controller? I have installed that and it still doesn't recognize. Please help. Thanks