Unsolved
This post is more than 5 years old
14 Posts
0
6408
Voltage error when I remove a SCSI card from 2950
I am re-purposing a PE2950. There is a "A320" SCSI card in the system that is not used.
After I remove the card, The system will not boot and gives a Voltage error e1000 fault
If I put the card back in the system it boots fine(?)
Are there steps I need to follow for card removal?
Thanks
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
April 28th, 2015 08:00
Evanspa,
There is no standard procedure to remove this card. With the “A320” SCSI card removed, drain the system flea power by disconnecting all power cables then pressing and holding the power button for about 15 seconds. Reseat all powers supplies and cables, backplane and PCI cards. Power on the System and see whether it boots.
Please let us know if you have any further questions.