Unsolved
3 Posts
0
2012
after import foreign configuration on h310 no operating boot
hello engineers
i have server t320 there raid 1
the hard disk 1.0 first is damage and replaced with new one after to boot to ctrl+r to raid configuration
i see new hard is foreign and show me two options 1 - clean or 2 - import
i did import and they are online and delete vd and recreate it
but when server booting show message
no operating system available on the device
i really afraid if the data lost and operating system
what solution you have dear engineers
best regards
DELL-Chris H
Moderator
Moderator
•
8.4K Posts
0
August 28th, 2018 07:00
Baarabi24,
When you replaced the failed drive, was the Virtual Disk booting? If so then you should have cleared the foreign, not import it.
Now to confirm, you stated "i did import and they are online and delete vd and recreate it ", did you in fact delete and recreate the virtual disk, and if you did, did you allow it to initialize the Virtual Disk as well? If so then the data would have been deleted when the drives were formatted. If you didn't initialize the Virtual Disk after recreating it, then it didn't format the drives, but if after reconfiguring the Virtual Disk you didn't then remove the replacement drive before booting, then it may have corrupted the data.
Let me know.
baarabi24
3 Posts
0
August 28th, 2018 11:00
i not initialize the Virtual Disk after import foreign config
DELL-Chris H
Moderator
Moderator
•
8.4K Posts
0
August 31st, 2018 07:00
What are the Physical Disk showing their status as, Online, Ready, Failed, etc?