1 Copper

Dell PowerEdge R410 - What is required for boot

Hello. I have a system with specs below.

2x Intel Xeon E5620 4c + dual tower coolers

20gb Samsung Reg ECC DDR3 @1600mhz

Dell PowerEdge R410 Motherboard 3GTGH.

A 300w Hipro out of a different dell from the same time period.

I have already followed a different thread here to modify the PSU pinout to work with this board.

 

I'm wandering how to get it to boot. I tried bridging all the pins to the front panel connector and this didn't work.

What all is required to boot? I assume front panel, but is anything else like a PCIe riser card required to boot.

Labels (3)
Reply
1 Reply
Highlighted
Moderator
Moderator

Re: Dell PowerEdge R410 - What is required for boot

Hey there @RyzenMaster,

 

This is the Minimum required components for a PowerEdge R410 to POST:

 

Risers
CPU1 (minimum for troubleshooting)
Heatsink for CPU1 for prevention of overheating
1 DIMM for CPU1
Power supply
Control panel
Motherboard
Power distribution board

 

 

Regards.

logo
 Diego López
 
 Social Media and Communities Professional
 Comunidad Dell | @DellAyudaPro | Eventos en línea
Reply