Highlighted
8 Krypton

PowerEdge 1950 Gen II - No power sensor information available for this system (PM_BUS)

When using DRAC 5 power management monitoring tools I get an error as follows:

No power sensor information available for this system.   

Same when I go to Hardware Performance

Hardware Performance Feature is supported on Platforms having PM_BUS

Is there a module that I could add to the PE1950 Gen II?

0 Kudos
3 Replies

RE: PowerEdge 1950 Gen II - No power sensor information available for this system (PM_BUS)

Hello.

The 1950 server does not support this feature. Even the supported power supplies are not energy smart for self monitoring.

Robert Alakara

Dell EMC | Enterprise Services

0 Kudos
8 Krypton

RE: PowerEdge 1950 Gen II - No power sensor information available for this system (PM_BUS)

Robert thanks for your constant support.

Is there an additional module we can install by any chance.

0 Kudos

RE: PowerEdge 1950 Gen II - No power sensor information available for this system (PM_BUS)

Unfortunately, I am not aware of any other module that can be installed to support the said feature.

Robert Alakara

Dell EMC | Enterprise Services

0 Kudos