This post is more than 5 years old
5 Posts
0
93344
Poweredge R410 without case, HDD, fans.
Hello,
I have a motherboard with 24GB RAM, 2X XEON, 2X PSU, 2x fans, and front panel.
When I push the power button the id led starts blinking orange.
What can I do to start the system?
Thank.
DELL-Daniel My
Moderator
Moderator
•
6.2K Posts
1
January 29th, 2016 15:00
Hello
These are the minimum to POST requirements for the R410:
It sounds like you may be missing the risers.
Thanks
pcbacon
1 Message
0
February 12th, 2016 18:00
I have a similar situation to his i have the riser but i am using a normal ATX psu is that fine? But i do not have the front panal do i need it %100 to make it post because the front panels are kinda expensive or could i just conect two pins in the pin layout on the motherboard?
kapcom01
5 Posts
0
February 19th, 2016 07:00
I am not an expert but I suggest you not to use the ATX PSU because according to the manual of the motherboard the pinout table is completeley different from ATX and it clearly states that is not ATX compatible. It will probably damage your motherboard. I also tried to power on the board without the front panel board and didn't succeed.
Pawel410
4 Posts
0
September 14th, 2017 00:00
U can't use Normal atx :D power supply beacuse pins are diffrent :D I Make this modification in this post
this is polish language. But u can use translator and u will se what u need :)
To Transform ATX to DELL Standard ":)
http://www.elektroda.pl/rtvforum/topic3329586.html#16407997