I have 1 question, i need to know that windows server 2008 R2 64 bits is compatible with the server DELL PE2850.
Thanks in advance...
Thanks theflash1932 for your replay.
You think that the following config is good to install the windows server 2008R2:
Processor: 2 Xeon 3,6 GHz
Memory: 4 GB RAM
Motherboard: Chipset Intel E7520
HD: 1 HD 146 GB
Thanks in advance...
If this server is just going to be used as a learning/training server or will be loaded with VERY basic services that do not require a lot of disk space, data redundancy, uptime, and/or read/write performance (database, encoding, compiling, etc.), then the configuration should be ok. Otherwise, I would seriously consider upgrading your memory/RAM and adding additional hard drives to your system.
I have exactly the same question. I successfully installed Win2k8R2 64 bit on a PE2800 from scratch, but am trying to upgrade a PE2850 that has Win2k3SP2 and 3 partitions on a RAID-5 array including C:. Everytime I try to install Win2k8R2 64 bit STD, it does not see my existing PERC 4e/di RAID-5 controller and wants a driver. Dell does not seem to list any compatible 4e/di 64 bit drivers. I do see a PERC 4e/dc driver that others claims works. Why the difference between the PE2800 with a PERC 4e/di RAID controller that installs from scratch, but the PE 2850 will not. Even when I reformat the C: partition and start for semi-scratch?
I'm not sure I follow. Below is the 2008 R2 driver for the onboard PERC 4e/Di, which is the same onboard controller in both a 2800 and a 2850 ... from the Drivers and Downloads page, SCSI RAID section for the 2850:
I did find this driver there:
LSI-LOGIC_MULTI-DEVICE_A00_R227150.exe (158KB)Recommended8/7/2009 184.108.40.206, A00 Applies to:
If I boot the 2850 to my Win2k8R2 install DVD and pick Upgrade, it says to reboot the server to the installed OS (Win2k3) and do the installation from within Win2k3. But when I do that, WIndows says it's a non-compatible version.
My only other choice is to select the other install option when booting to the DVD and over-write/reformat the C: partition. I've tried that after manually reformatting C:, but then the DVD says it cannot find any HD to install to and wants a RAID driver. If I then point the installation process to the above file I've copied to the 😧 partition of this server, will it install OK?
I see the installation instructions under the Driver details which specify running the driver file .exe to create diskettes (floppy disks). Can this process work with a USB stick on the PE2850?
This will work with USB, not because the 2850 supports it, but because 2008 R2 supports obtaining a driver from USB, CD and floppy. Floppies are the only supported method of obtaining a third-party driver during Setup of 2003/XP and earlier operating systems; thankfully, having left those dinosaur OS's behind, we have other simpler options 🙂
You simply run the file to extract its contents, then copy the extracted contents/files to the media to be used to load the driver.
Coincidentally, however, the 2850 does support booting to USB devices, so you could put your 2008 R2 installation files AND drivers on the same bootable USB flash drive and install using that, pointing to a folder on that same drive for loading the driver.