Unsolved
This post is more than 5 years old
2 Posts
0
882
Service Interface Menu not appearing for Dell Power vault MD3820i
To change the default IPs I have deleted the IPS configured in the eth1 and eth2 and restart the storage to take the changes in effect. After reboot I tried to connect to the storage via micro USB port connection. After I press the Crtl + Pause, I am getting the usual prompt "Press within 5 seconds: for Service Interface, for baud rate"
I have given "S" but I am not getting service interface Menu.
Please let me know how to configure the IPs for the eth1 and eth2.
DELL-Sam L
Moderator
Moderator
•
6.9K Posts
0
February 19th, 2018 08:00
Hello Muthu1936,
To configure the ISCSI ports on your MD3820i you can use MDSM or SMCLI. You can only change the management ports via serial ports. Is this a new install of your MD3820i? If it is a new install, then here is the deployment guide as it will assist you with your install. http://topics-cdn.dell.com/pdf/powervault-md3800i_deployment%20guide3_en-us.pdf
Here is also the Administrator guide & if you look on page 57 it explains how to configure your ISCSI settings. http://topics-cdn.dell.com/pdf/powervault-md3400_administrator%20guide_en-us.pdf
Last here is a link to the SMCLI guide. http://topics-cdn.dell.com/pdf/powervault-md3400_cli%20guide_en-us.pdf
Please let us know if you have any other questions.