Unsolved
This post is more than 5 years old
1 Message
0
12464
Receiving an error in the event log after firmware update
I'm receiving the following error ever since firmware was updated on my MD3000:
The operation cannot complete because the connection to the storage array has been lost. Possible causes include network or connection problems, controller problems, or no power to the Host or storage array. If you just changed the logical unit number (LUN) mapping for an access volume, you must restart SANtricity Storage Manager Agent for the change to take effect. If you suspect a controller problem, use the Recovery Guru in SANtricity Array Management Window.
mrokkam
154 Posts
0
October 18th, 2010 09:00
Do you manage your MD3000 in-band or out-of-band? What OS are you using?
For this kind of problem, I would recommend contacting Dell support.
-Mohan