Unsolved
1 Message
0
2501
T3610 RAM
I removed all existing ram from my Dell Precision T3610 and inserted a 16gb stick of compatible ram (A7187318) in dimm slot 1 (all other slots remain empty) but the system fails to boot. Removing the new ram and reinserting the old ram works fine. Am I missing something obvious here? Thanks!
bmcowboy
573 Posts
0
May 31st, 2019 11:00
Hi @lezgoyanks ,
What is the Diagnostic LEDs looks like when fail to boot? You may refer to T3610 Owner's Manual starting from page 53.
fireberd
9 Legend
9 Legend
•
33.3K Posts
0
May 31st, 2019 11:00
Did you verify the memory module was fully (and correctly) seated in the socket?
Also, sometimes the BIOS must be reset to recognize new memory. It shouldn't be but sometimes it needs reset.
Before you reset the BIOS (the reset will set it to the original factory defaults) if you have any customization note that as it will have to be re-entered after the BIOS reset.
To reset the BIOS, power off the PC, open the case and locate the CR2032 (CMOS) coin cell battery on the motherboard. Remove the battery for at least 10 minutes. Reinstall the battery, observing polarity. Power on and see if the new memory is recognized.