Unsolved
This post is more than 5 years old
14 Posts
0
2217
discover AIX stop @ 27%
Hi, I am trying to doscover a AIX via ssh. The status is running, but it have been running for for than an hour. Could it be some process hung?
Unsolved
This post is more than 5 years old
14 Posts
0
2217
Hi, I am trying to doscover a AIX via ssh. The status is running, but it have been running for for than an hour. Could it be some process hung?
Top
standiferl
2 Posts
0
May 13th, 2013 11:00
My AIX discoveries run for hours sometimes. When you group them together like i do i just run the discovery and come back later or at the end of the day and it should complete.
cincystorage
467 Posts
0
May 14th, 2013 03:00
Did this job complete?
ecinv1
14 Posts
0
May 14th, 2013 06:00
It did't not fully complete. It was not able to discover topology. "No Response From Topology Service"
cincystorage
467 Posts
0
May 14th, 2013 06:00
Did it have a corresponding error code either displayed or shown in the error logs?
ecinv1
14 Posts
0
May 15th, 2013 19:00
the full message is:
"Probing ALL information about Host hostname from provider at IP xx.xx.xx.x using Access Credentials AIX Access Credential complete
Invoking Topology Service on hostname_of_prosphere_application_server.domain.com
Timed out while waiting for Topology Service to process data
No Response From Topology Service
Task ID :CMP_DiscoveryTask-ECIM-t8SfDU2ob8YqD1x3uWkNFyhtkg76-1368164186236 "
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
June 19th, 2013 07:00
Hi ecinv,
You can use the below mentioned link to check if the Topology Service is running or not:
https:// /cgi-bin/mon.cgi
Also, try to Power Off and then Power On the Prosphere vApp in vCenter and then run the discovery job again.
In case the issue still persists, I would recomend opening a service request with EMC as there may be some other parameters that need to be looked into.
Hope this helps.
Thanks,
Madhur