How can I remove VLAN with SSH access line code ?

Hello,

It depends a lot of the OS you installed.

Could you gave me more information about it, it'll help me to forward you the right troubleshooting steps.

Wish you a good day.

Best regards,

Hello

it's on a Dell Networking N2048 System

don't know where I can find the OS version....

Thanks

No problem, thanks for this additional information.

I forward you the guide about this switch:

https://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_networking/esuprt_net_fxd_prt_swtchs/networking-n2000-series_user%27s-guide11_en-us.pdf

you'll be able to see those informations:

switchport mode Use the switchport mode command in Interface Configuration mode to configure the VLAN membership mode of a port. To reset the mode to the appropriate default for the switch, use the no form of this command.

access—An access port connects to a single end station belonging to a single VLAN. An access port is configured with ingress filtering enabled and will accept either an untagged frame or a packet tagged with the access port VLAN. Tagged packets received with a VLAN other than the access port VLAN are discarded. An access port transmits only untagged packets

it'll help you to put all your ports in the same VLAN for example.

Hope this will help you to solve your issue.

Best regards,