Unsolved
This post is more than 5 years old
104 Posts
0
2873
How to force remove vrpa from the vrpa cluster (version 5.0 SP1)
As title. I cannot find any information in admin & deployment guide and EMC KB portal. This is my lab environment, anyone help me ?
Victor Wu, Senior Solution Architect
Victor Wu
104 Posts
0
August 7th, 2017 02:00
Due to that node is corrupted, deployer currently cannot access the original IP address. So I cannot remove it in deployer, I think that only remove it by CLI.
Victor Wu
104 Posts
0
August 7th, 2017 02:00
No. It is not classic RP, it is RecoverPoint for VMs 5.0.Due to one vRPA is corrupted in vRPA cluster (2 nodes), I have added one new vRPA into the running cluster, this vRPA cluster is health now. But the old one configuration is still in cluster, I hope to remove that node, how to do it ?
forshr
1.1K Posts
0
August 7th, 2017 02:00
If yoiu are using classic RP then this is not possible.
Regards,
Rich
forshr
1.1K Posts
0
August 7th, 2017 02:00
Have you tried the option in Deployer?
forshr
1.1K Posts
0
August 7th, 2017 03:00
There is a utility that can be used through Support that may resolve the issue with vRPA1 so would recommend raising an SR.
Victor Wu
104 Posts
0
August 7th, 2017 18:00
Due to we just in POC phase now, so it doesn't have any support contact active now. Do you have this utility ? Can you share to me, thanks.
forshr
1.1K Posts
0
August 8th, 2017 01:00
You could use the replace option. This doesn't require the vRPA to be reachable.
prabhusingh
1 Message
0
October 26th, 2018 01:00
Hello,
I do facing similar issue with same config of vRPA Cluter. I was unable to replace the faulty RPA 1.
Getting following error "Could not retrieve vCenter server credentials for RPA 2" while trying to replace the RPA.
Ref: SR#12468003
Idan
675 Posts
0
October 27th, 2018 23:00
Hi there,
In this specific case, it's an issue due to a failed upgrade (as RPVM cannot be upgraded directly to 5.2, has to go through 5.1.1.4/5), we would need to get info on the VMs listed in the SR to further troubleshoot this one.
Hope that helps,
Idan Kentor
Sr. Principal Product Technology Engineer - RecoverPoint and RecoverPoint for VMs
@IdanKentor
idan.kentor@emc.com