May i know where can i download EMC RPA stencil?

Hi Ivan,

There is a stencil repository on PowerLink but unfortunately it's only available to EMC Employees and Partners. What do you need and I can send it do you?

Regards,

Richard (RecoverPoint CSE)

Helo! Can you send me visio stencil of EMC RPA too? I can't find it anywhere..

My mail:  jorjia@mail.ru

thanks a lot!

I am looking for the stencile for the RPA Gen 5. Is there one avaliable?

Is there a usable working visio stencile? The .bmp is the correct configuration, but I need something to work in Visio.

Regards

See attached.

Thanks, not exactly what I was looking for. I guess I will create my own.

Thanks for trying.

Maybe this location is what you are looking for. Remember those RPA's are Dell servers. http://mikes.eu/index.php/useful/visio-stencils.html

I am out of the office until 24/06/2013.

Note: This is an automated response to your message "Re: -

May i know where can i download EMC RPA stencil?" sent on 20/06/2013

12:54:52.

This is the only notification you will receive while this person is away.

I have gone through the Dell stencils and have used may of them. Nothing for the RPA Grneration 5 devices.

Thanks

I am out of the office until 24/06/2013.

Note: This is an automated response to your message "Re: -

May i know where can i download EMC RPA stencil?" sent on 20/06/2013

16:49:55.

This is the only notification you will receive while this person is away.

I don't recall where I found these, though I believe it was on http://support.emc.com/ and these were listed a Appliance Servers.  These are the closest I've found to a RecoverPoint Gen5 appliance, add a 4 port HBA to the rear stencil and it works well enough for documentation.

PERFECT, Exactly what I was looking for.

Thanks