This post is more than 5 years old
18 Posts
0
686
RPA waiting F1 after reboot
Hello RPA Community
I have a little problem with one of the RPA that is 100km far away from my office in a Datacenter.
This morning I have rebooted it.
Since this operation I cannot ping it anymore.
I've already encountered this problem a while ago and in fact the RPA was waiting for the F1 key to be pressed.
How can I avoid this kind of problem ?
I thought I could configure IDRAC to have acces remotely but with GEN5 it's not possible.
There an other solution : BMC ? Am I right ?
Which port should I cable ?
Thanks for your answers.
Regards
forshr
1.1K Posts
0
July 31st, 2014 04:00
My mistake. You'll find it in the RecoverPoin Security Configuration Guide.
forshr
1.1K Posts
0
July 30th, 2014 07:00
Yes, the Gen5 RPA is an Intel box so it uses BMC. Search for BMC in the RP Admin Guide and you'll find what you need.
Regards,
Rich
jlarchev_samse
18 Posts
0
July 31st, 2014 04:00
Hi,
I looked in the admin guide but I could not find anything about it ...
jlarchev_samse
18 Posts
0
July 31st, 2014 04:00
Thanks a lot Rich.