__15
1 Copper

Using SAN Copy replicate Data from CX4(Unisphere) to P2000

Dear all,
i try to config replicate data from CX4 to P2000 using SAN Copy(FC).
any Recommned Please!
- how i can Zone?
- which type of replicate can i use pull or push?
- how can i config to replicate?


i read SAN Copy admin guide but i can not see this document talk about 3rd party

thanks & regards
Tuan.

Tags (2)
Reply
3 Replies
Highlighted
JamesBEMC
3 Argentium

Re: Using SAN Copy replicate Data from CX4(Unisphere) to P2000

Hi Tuan

Im sorry - SAN Copy is only supported on EMC to EMC Arrays.

James.

Reply
Highlighted
avs
2 Iron

Re: Using SAN Copy replicate Data from CX4(Unisphere) to P2000

Hello

SAN Copy can be used with EMC and non EMC arrays.

Check E-Lab Interoperability Navigator for P2000 compatibility.

The best way is to zone both storage processors of two boxes.

Pull will be used when you copy data to CX4 and push will be used when you copy data from CX4.

To configure SAN copy need to setup lun masking on P2000 for WWN/iqn of CX4.

Use LUN UID to point replication to particular LUN on P2000.

Alex

Message was edited by: avs

Reply
Highlighted
dynamox
6 Thallium

Re: Using SAN Copy replicate Data from CX4(Unisphere) to P2000

I assume this is HP P2000? If yes, it's not on the support matrix. It's very similar to MSA 1000 that is on the support matrix so it's possible you can ask for an RPQ.

Reply