Velitel
1 Copper

HotSpare drive replacement fails

Jump to solution

Hi all,

I have problem to replace bad HS disk drives on DMX3 with Enginuity 577.105.94. Procedure stops on step 19 with message "Drive failed to initialize". If I repeat the procedure with another new disk drive, the result is the same and also doesn't matter at which position is the bad HS disk, it fails always. The Enginuity is the same for long time, some months ago the Procedure ran well.

Please, is this problem known to someone?

0 Kudos
1 Solution

Accepted Solutions
Kleanthis76
2 Bronze

Re: HotSpare drive replacement fails

Jump to solution

Hi Velitel,


Please check emc243335. I think this is your issue.

Regards,

Kl.

0 Kudos
3 Replies
Kleanthis76
2 Bronze

Re: HotSpare drive replacement fails

Jump to solution

Hi Velitel,


Please check emc243335. I think this is your issue.

Regards,

Kl.

0 Kudos
Highlighted
Velitel
1 Copper

Re: HotSpare drive replacement fails

Jump to solution

Hi Kleanthis,

thank you very much, I hope this helps. Will update later.

BR

Ivan

0 Kudos
Zikas
3 Argentium

Re: HotSpare drive replacement fails

Jump to solution

Hi Velitel,

the option to have "Drive failed to Initialize" is when:

the disk is DOA

the disk is smaller than the one you are going to change

the disk has different Bits Per Sec BPS

the disk is different technology

the disk has not the same P/N

If you are going to use a bigger disk than the one is used, you are going to be asked if you want to continue.

Hope that i helped you

0 Kudos