Unsolved
This post is more than 5 years old
1 Message
0
1061
How do I map and mask dmx devices to multiple recoverpoint fc initiators with smc 6.1?
I'm trying to provision recoverpoint journals. I created metas at each site and need to present them to four RA's per site. SMC 6.1 will map metas to FA ports, and mask them to one initiator per port. It will not add initiators for additional RA's. We have DMX4 with ECC 6.0 and SMC 6.1 at site 1, DMX1000 with SMC 7.1 at site 2. Thanks!
Booyah2
184 Posts
0
November 16th, 2010 07:00
Initiator mapping is for front-end (FA) directors only.
To create your RA (RF) mapping, you need to create SRDF device pairs between the two arrays.
You would first have to add the RDF attribute to your new meta's before you could create a RDF device pair.
you can first create a DG / CG with your devices if desired or just map them with a device file.
I have attached the Product Guide for you review, it describes these steps in detail.
Hope this helps.
Best Regards,
REMINDER:
If you find any of the replies to your question as helpful, please be so kind as to mark replies as being "helpful" or "answered". This helps us track our success with the Forum.
1 Attachment
SE Array Controls 300-002-940_a08.pdf