Unsolved
This post is more than 5 years old
2 Posts
0
3702
Clarification needed for blade CMC and iDRAC
Hi!
I am a first-time Dell blade user and have some confusion.
I have setup CMC IP, and can connect to the web interface.
When I attempt to call iDRAC GUI and remote console on each blade via the CMC web interface, however, the pop-up windows shows some "connection failed" message. This appears on Firefox and IE9.
Did I miss any neceassary steps during the setup?
I am a first-time Dell blade user and have some confusion.
I have setup CMC IP, and can connect to the web interface.
When I attempt to call iDRAC GUI and remote console on each blade via the CMC web interface, however, the pop-up windows shows some "connection failed" message. This appears on Firefox and IE9.
Did I miss any neceassary steps during the setup?
Phuzzi
13 Posts
0
October 20th, 2010 02:00