Anonymous
Not applicable

VMAX 850FX

Hi all

i need to add IP address to the RE ports which are currently showing as offline,

just wondering if this is still binfile change or can i do it by Cli?

array type VMAX850FX

solution enabler v8.2.0.0

i have found the following commands and in the cli guide.

symconfigure set port DirectorNum:PortNum[FlagName = enable | disable]

[, ...] ]

gige primary_ip_address = IPAddress primary_netmask =

IPAddress,default_gateway = IPAddress,

isns_ip_address = IPAddress primary_ipv6_address =

IPAddress,primary_ipv6_prefix=<0-128>,

[fa_loop_id = Integer] [hostname = HostName];

Restriction

This command cannot be used to set port characteristics for iSCSI physical front end

ports and iSCSI target virtual ports. Use the modify iscsi_target on page 271 command.

thanks

taj

Labels (1)
0 Kudos
2 Replies
KW160
3 Argentum

Re: VMAX 850FX

SRDF RE Port IPs can only be changed by BIN file.

That specific command you've referenced can only be used for Front-End iSCSI host ports on older generation VMAXes.

Anonymous
Not applicable

Re: VMAX 850FX

With Solutions Enabler 8.4, is BIN file still required to change IP addresses on RE ports?

0 Kudos