Unsolved
This post is more than 5 years old
12 Posts
0
2617
Celerra Network config
customer has an NS80 that we recently had to change from a 4port trunked config ( MLT ) to a fail safe config.
I noticed in Celerra Manager that the only option is to choose one (1) cge port of the six (6) available as primary and 1 as standby...
two questions...
1) is the option available to choose more than 1 port active and 1 standby to two active and 2 standby
2) is there a default setting that needs to be changed as we can no get the standby port to go "live" when we take to the "primary" port down to test.
any assistance here would be greatly aprpeciated...
Richard Boyer
EMC Federal On-Site Resident
for USPTO
571-272-5634
boyerr
12 Posts
0
November 9th, 2009 10:00
kendcollins
40 Posts
0
November 10th, 2009 08:00
Richard,
This forum is more for developer information and issues rather than customer issues. You can go to the Celerra Forum (http://celerra.emc.com/clearspacex/index.jspa) and place your post there. You will most likely receive a very timely and appropriate response.
Ken Collins
Rainer_EMC
8.6K Posts
0
November 15th, 2009 15:00
If you want more than one interface you need to build one or two trunk devices first and then put a FSN on top of it
see the Networking High Availability manul
Rainer
P.S.: since you are an EMC employee please use the internal Celerra forum at celerra.emc.com