Unsolved
This post is more than 5 years old
2 Posts
0
3651
Fail to Login to EMC VNX5300
Dears,
Please help we are facing a serious error the most important thing that we can ping the Storage Process Module (SPA, SPB) but we cannot login to it "Server not response", also if we login to the control station (CS0) login error as shown in the attached image.
Thanks,
Rainer_EMC
8.6K Posts
0
November 4th, 2013 14:00
Try if you can ssh (putty) into the control station and if you can open http:///setup
IF that works then most likely your system is fine and you have one of the problems with UniSphere login or certificates mentioned in your screenshot
o17Uu33DCF12520
1.1K Posts
0
November 4th, 2013 17:00
Did you happen to create/change the login on one of the block/file side and not sync it up to the control station?
check this out: https://support.emc.com/kb/75213
o17Uu33DCF12520
1.1K Posts
0
November 4th, 2013 18:00
check if this solution works for you.
https://support.emc.com/kb/85807
in additional, you could also try this.
Login to the SP through the management port using a laptop computer and disable the IP Filtering State.
--> Setup page
--> "Set Administration Access Restriction"
--> IP Filtering State: "Disable"
Vipin VK
812 Posts
0
November 4th, 2013 19:00
Is this a new install ?
Ensure you have accepted the security certificates and the CS-DM-SP
connectivity is proper. If not tried, try logging in from different
system/browser.
h_hammoud
2 Posts
0
November 5th, 2013 14:00
Dears,
I've try all what you talk about but nothing works even if you connect to the service port you can ping it but you cannot browse the unisphere from it, using putty it login successfully but I don't know my the user name and password knowing that no one change them if you know what is the default credential for SP service port.
Thanks,