Unsolved
This post is more than 5 years old
104 Posts
1
4411
Unisphere Remote Ports
Hi,
can someone provide me the PORTS needed for unisphere Central to Monitor VNX. Can't find anything in the documentation.
Could it be that it's only Port 80/443
Thank You
Sebastian
Sebbo1
13 Posts
0
September 2nd, 2014 00:00
Nice thank you... whrere did you found that list?
Regards
rewalmilo
62 Posts
0
September 2nd, 2014 00:00
From the
EMC Unisphere Remote
2.0.0
Installation Guide
P/N 300-013-602
REV A02
Note: Verify that ports 80/443 are open prior to installation. The GUI client
communicates with the Unisphere Remote server using these ports. VNX and VNXe
systems and the Unisphere Remote server communicate with each other using these
ports.
Jeffey1
2.8K Posts
0
September 2nd, 2014 00:00
The following table lists IP ports used by VNX Family Monitoring and Reporting to access arrays. These ports need to be opened from Monitoring and Reporting to VNX and VNXe arrays.
For more information about monitoring VNX, you can read the document of VNX Family Monitoring and Reporting. If my answer is helpful, please help with marking it. Thank you!
Jeffey1
2.8K Posts
0
September 2nd, 2014 00:00
Hi Sebbo,
The list is from the document of Security Configuration Guide on VNX for Block, page 15.
Jeffey1
2.8K Posts
0
September 2nd, 2014 00:00
The ports used by the various components to pass data back and forth are an important aspect of Unisphere communication. You must understand which network ports are required by the various Unisphere components.Table below lists the unisphere components and ports that are used for communication: