Unsolved
10 Posts
0
3118
Unisphere page is not working using control station ip
Hello everyone,
I am facing an issue after replacement of control station of my vnx 5700 whenever I am trying to login through putty using nasadmin , following notification has appeared. need advice as I am out of support contract.
EMC NAS Service is not running due to one of the following reasons:
1. EMC NAS Service is still starting or there was an error during
service start-up.
Please logout and try logging in after 5 minutes. It can take up to
15 minutes after Control Station boot for EMC NAS Service to start.
If the problem persists after 3 login retries, please reboot the
Control Station and try again. If this message is still displayed,
contact EMC Customer Support.
2. EMC NAS Software upgrade is in progress, which required stopping
the Service temporarily.
Please DO NOT use the administrative interface while EMC NAS Software
upgrade is in progress. EMC NAS Service starts automatically after
the upgrade finishes.
I have used 7.1.76.4_emcnas_DVD .
Rainer_EMC
8.6K Posts
0
October 18th, 2018 05:00
Have you followed the control station replacement procedure from Solve ?
Muzammil_Ubaray
10 Posts
0
October 18th, 2018 05:00
Yes, I have followed the procedure generated from solve Desktop. I can ping the Sp's from the control station.
DELL-Sam L
Moderator
Moderator
•
6.9K Posts
0
October 22nd, 2018 11:00
Hello Muzammil_Ubaray,
Have you tried to restart the control station to see if you are getting the same error? Are you only getting this error on the primary control station or on both?
Please let us know if you have any other questions.
Muzammil_Ubaray
10 Posts
0
October 23rd, 2018 00:00
Hi Saml,
I had reboot the control station but still getting the same result when login using as nasadmin . I have only control station in the system.