Unsolved
7 Posts
0
1785
VNX 5200 peer IP change
HI
VNX5200 Peer IP problem.(I do not know why this is because I did not make the initial settings.)
I can not access Unisphere
SPA IP : 192.168.196.112
SPB IP : 192.168.196.113
Applied https:xxx.xxx.xxx.xxx//setup peer IP address.(I do not know why this is because I did not make the initial settings.)
How do I change Peer IP?
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
August 27th, 2018 05:00
Hi,
It is best way to open SR and ask help for remote support for this.
There are 2 ways of doing this;
1- from /setup (This cause SP reboot)
2- from navicli commands (This cause just management service restart)
Here are some examples for navicli commands;
naviseccli -h 128.221.1.250 -user sysadmin -password sysadmin -scope 0 networkadmin -set -ipv4 -address 10.240.88.218 -subnetmask 255.255.255.192 -gateway 10.240.88.250
naviseccli -h 128.221.1.251 -user sysadmin -password sysadmin -scope 0 networkadmin -set -ipv4 -address 10.255.254.75 -subnetmask 255.255.255.0 -gateway 10.255.254.1
naviseccli -h 128.221.1.250 -user sysadmin -password sysadmin -scope 0 networkadmin -get -ipv4
You may use these commands while you are connected to SP service ports.
yajtsav
4 Posts
0
August 31st, 2018 07:00
Hi,
is it Unified or Block only?
Rainer_EMC
8.6K Posts
0
September 3rd, 2018 06:00
the example is for block only
unified is more work
follow the procedure in the knowledgebase
if unsure open a service request