This post is more than 5 years old
11 Posts
1
1531
vplex secondary volume utilized at100%
Hi All,
We have a A+A setup across vplex. When we checked the distributed volumes configured on VPLEX, we found that no matter the secondary volume configured on which storage, all the secondary volume’s utilized as 100% even the primary volumes hardly reached 100%.
Is this common behavior or is it because of some parameters configured anywhere.?
sathyaprakash.mohandass
41 Posts
0
July 5th, 2017 07:00
I believe you are talking about the capacity of the thin luns. You will need to make sure that both the volumes were claimed as thin and thin rebuild enabled. if either of these two parameters is not set. it will populate the entire capacity of the volume with zeros. This will happen to the side which is getting rebuilt.
darrenVCE
25 Posts
0
July 5th, 2017 00:00
So this is a VPLEX Metro configuration ? What is the backend storage on each site ? Where are you viewing the lun utilization information from ? Are both backend arrays configured the same or is there additional workload running on 1 array for local workload for example ?
ddeepak
11 Posts
0
July 14th, 2017 01:00
Thank you, it was issue. we are resolving it now..
Sorry the delayed response.